centrifugal separator  

Inline Centrifugal Separators

centrifugal separator | Inline Centrifugal separator | gas liquid separator

These separators are designed for horizontal or vertical down flow and remove liquids or solids from a vapor stream.
The following models fit this need:

WL; WLB; WLUT; WLC

The simplicity of the operation of these units with our patented “Whirl-A-Way” internal is the reason for the success of this type of entrainment separator. Liquids and solids will precipitate from gases by the forces of gravity alone, but by whirling these gasses through fixed directional vanes, separating forces can be multiplied many times due to centrifugal action.
All of these separators deliver 99.9% of all particles 3-8 microns and larger and can be fabricated with any material that can be formed and welded.

Precaution: Not recommended for liquid loadings over 10%. If solids are present, the unit must have sufficient amount of liquids to flush the solids out to drain.

WL | Click to View Outline
Use: For removal of liquids or solids from a vapor stream where no storage capacity is required
Configuration: Horizontal or Vertical downflow.
Operating Range: 35% to 115%
Features: Self Cleaning
Low Cost

WLB | Click to View Outline
Use: For removal of liquids or solids from a vapor stream
Configuration: Horizontal
Operating Range: 35% to 115%
Features: Limited Storage capacity is available
Self cleaning
Low Cost

WLUT | Click to View Outline
Use: For removal of liquids or solids from a vapor stream
Configuration: In-Line Vertical Upflow
Operating Range: 35% to 115%
Features: Self Cleaning
Low Cost

WLC
Use: For removal of liquids or solids from a vapor stream in which the liquid particles are very small micron size
Configuration: Horizontal In-Line or Vertical Downflow
Operating Range: 35% to 115%
Features:

  1. A coalescing element, placed upstream of a separating element allows very small liquid particles to build up until they are large enough to be separated a boot can be added if liquid storage is desired. Can be furnished with body flanges to facilitate cleaning of coalescer element.
  2. Low cost.
  3. Self cleaning.
Copyright © 2009 Dyna-Therm Corporation. All Rights Reserved. an Orange Sparrow Design by PetroPages.com